Surface Preparation

• Ensure all bonding surfaces are clean, dry, and free from dust, grease, or loose particles.
• Cut the nozzle tip to the desired bead size (recommended 5mm opening).
• Apply under suitable ambient conditions; avoid application on wet or frozen surfaces.

Application Instructions

• Apply a continuous bead or a series of beads to the substrate.
• For large surfaces, apply beads approximately every 40 cm to ensure full coverage.
• Position components immediately and press together firmly.
• In high-stress applications, use mechanical fasteners or clamps to maintain contact.
• Repositioning is possible for up to 20 minutes after assembly.

Curing & Limitations

• Allow a minimum of 24 hours before removing temporary clamps or supports.
• Avoid stressing the bonded joint during the full 7-day cure period.
• Do not apply to surfaces that are wet, damp, or contaminated.
• Not suitable for structural bonding or continuous water exposure.